蓝牙参数整理

📎 原始文档：https://www.kdocs.cn/l/ctt2q1kLmTWd | | | | | | |---|---|---|---|---| | 系列参数 | | | | 蓝牙6.0协议版本号： | | Operation Frequency Range | 2402-2480MHZ | | | =DISPIMG("ID_FEB6505615B9415FBF76C2D96701F2F4",1) | | Bluetooth Version | 5.4+BR+EDR+BLE | 根据系列实际填写（参考规格书） | | | | （低功耗蓝牙）BLE Channel Number | 40 | | | | | BLE Channel Separated | 2 MHZ | | | | | Modulated Type | GFSK、 π/4-DQPSK、8DPSK | 根据系列实际填写（参考规格书） | | | | （经典蓝牙）Bredr channel Bandwidth/Channel Separattion | 1MHz | | | | | （经典蓝牙）Bredr Channel Number | 79 | | | | | Data Rata | 30k bps | | | | | 支持BR (GFSK) | Peak Power(dBm)(with Tolerance) 7.2 | Avg. Power(dBm)(with Tolerance) 6 | | | | BR (GFSK)+ EDR | | | | | | (GFSK + π/4DQPSK) | | | | | | EDR (GFSK + π/4DQPSK） | | | | | | 支持　BLE(1M) | | | | | | 支持　BLE(2M) | | | | | | 支持Dual mode BLE + (BR and EDR) | | | | | | Antenna Type | 根据样机的天线形式填写（如：板子载、陶瓷）　 | | | | | Antenna Information | 陶瓷天线客户自己选　 | | | | | Transmitter Details | | | | | | Frequency range | 2402-2480MHZ | | | | | No. of preset switchable channels | 40 | | | | | No. of voice /Data/ TV Channels( In case of multi- channel equipment) | 3 | | | | | Tx-Rx channel separation( In case of Duplex/multi-channel equipment) | TX/RX in common | | | | | Adjacent channel separation ( In case of multi-channel equipment) | 2MHz | | | | | Frequency stability | 9ppm | | | | | Spurious/ Harmonic radiations | ≤-30dbm | | | | | Max. Frequency Deviation | 10KHZ | | | | | Bandwidth of emission | 1MHz | | | | | Base band frequency (In case of multi channel equipment) | 2402-2480MHz | | | | | Type of modulation to be required | GFSK | | | | | Receivers Details | | | | | | Frequency range | 2.402-2.480GHz | | | | | Sensitivity | -86dBm | 根据系列实际填写（参考规格书） | | | | Frequency stability | 9ppm | | | | | Threshold input level | 3.3V | | | | | Intermediate frequency | 2.441G | | | | | 支持解码格式 | SBC , AAC | | | | | 延时 | 250ms左右 | | | | | 声道分离度 | -50db | | | | | Mic 采样率 | mic采样率可以设置的，一般通话msbc都是16k | | | | | 占用宽带 | ≤ 3MHz | | | | | 发射功率 | 8db | 根据系列实际填写（参考规格书） | | | | core Specification Version | 5.4 dual mode | 根据系列实际填写（参考规格书） | | | | new features for bluetooth | LE 2M PHY(2x Speed 高速传输）、LE Coded PHY(4x RANG) | | | | | Porduct Type | End Product | | | | | Supported Protocols/底层 | | | | | | Part | Protocol | | | | | Core Controller | RF/ BB / LMP/ | | | | | LE Controller | RF-PHY / LL | | | | | Core Host | L2CAP/ SDP/ GAP/ GATT/ SM | | | | | Support Traditon Profile | | | | | | Profile | Version | Role | | | | A2DP | 1.3 | Sink | | | | AVRCP | 1.5 | Controller(CT) | | | | AVDTP | 1.3 | Sink | | | | AVCTP | 1.4 | Controller(CT) | | | | HFP | 1.5 | Hand-Free(HF) | | | | HID | 1.0 | | | | | RFCOMM | 1.2 | | | | | SPP | 1.0 | | | | | SDP | Core 4.2 | | | | | L2CAP | Core 4.2 | | | | | PNP | 1.3 | | | | | RF 经典蓝牙 IXIT for RF | | | | | | IXIT Reference | Description | Comment | Value | Unit ( if applicable ) | | RF:P1 | Timer for TX power control | TRM/CA/03 Power Control | 40 | ms | | RF:P2 | Inband Image frequency | RCV/CA/03 C/I Performance | -3 | MHz | | | | RCV/CA/09 EDR C/I Performance | | | | RF:P3 | Value n for Intermodulation test | RCV/CA/05 Intermodulation Performance | 4 | Integer | | RF:P6 | Type of power source | Chapter 6.4, RF Test Specification | 4.2 | | | RF:P7 | Nominal power source voltage | Chapter 6.4, RF Test Specification | 4.2 | V | | RF:P8 | Operating temperature range | Chapter 6.5, RF Test Specification | 30 | °C | | RF:P9 | Extreme power source voltage | Chapter 6.5, RF Test Specification | 4.2 | V | | RF:P10 | Antenna gain | Chapter 6.9, RF Test Specification | 0 | dB | | RF-PHY 低功耗蓝牙ICS for RF-PHY | | | | | | Item | Bluetooth LE RF Capability | Status | Supported | | | 1 | LE Transmitter (Non-connectable, Broadcaster) | C.1 | | Note：without 5.0 features，select Item1~3 | | 2 | LE Receiver (Non-connectable, Observer) | C.1 | | | | 3 | LE Transceiver (Connectable, Peripheral/Central) | C.1 | | | | 4 | LE 2M PHY | C.2 | | Note：Item 4~7 is BT5.0 features | | 5 | Stable Modulation Index - Transmitter | C.3 | | | | 6 | Stable Modulation Index - Receiver | C.4 | | | | 7 | LE Coded PHY | C.2 | | | | C.1: Mandatory to support at least one of these capabilities. | | | | | | C.2: Optional IF SUM ICS 21/16 “Core 5.0” AND RF PHY 1/3 “LE Transceiver” are supported, otherwise Excluded. | | | | | | C.3: Optional IF SUM ICS 21/16 “Core 5.0” AND (RF PHY 1/1 “LE Transmitter” OR RF PHY 1/3 “LE Transceiver”) are supported, otherwise Excluded. | | | | | | C.4: Optional IF SUM ICS 21/16 “Core 5.0” AND (RF PHY 1/2 “LE Receiver” OR RF PHY 1/3 “LE Transceiver”) are supported, otherwise Excluded. | | | | | | Item | Bluetooth LE RF Capability | Status | Supported | | | 1 | HCI Test Interface | C.1 | | | | 2 | UART Test Interface | C.1 | | | | C.1: Mandatory to support at least one of these capabilities. | | | | | | RF-PHY 低功耗蓝牙 IXIT for RF | | | | | | IXIT Reference | Identifier | Sub-Identifier (Optional) | Value | Units ( if applicable ) | | RF-PHY:P1:1 | Inband Image frequency | Low frequency | -3 | MHz | | RF-PHY:P1:2 | | Middle frequency | -3 | MHz | | RF-PHY:P1:3 | | High frequency | -3 | MHz | | RF-PHY:P2:1 | Value n for Intermodulation test | Low frequency | 4 | Integer | | RF-PHY:P2:2 | | Middle frequency | 4 | Integer | | RF-PHY:P2:3 | | High frequency | 4 | Integer | | RF-PHY:P4 | Type of power source | Nominal (NOC) | 4.2 | V | | RF-PHY:P5 | Operating temperature | Nominal (NOC) | 30 | °C | | RF-PHY:P6:1 | Air humidity range (relative) | Maximum | 70 | % | | RF-PHY:P6:2 | | Minimum | 70 | % | | RF-PHY:P6:3 | | Air humidity level for NOC/EOC tests | 70 | % | | RF-PHY:P7:1 | Test interface implementation | HCI or 2-wire UART | 0 | | | RF-PHY:P7:2 | | Datarate | 115200 | bps | | RF-PHY-PHY:P8 | Antenna gain | | | dBi | | RF-PHY:P9:1 | Maximum TX packet length(MAX_TX_LENGTH) | | 37 to 255 | Bytes | | RF-PHY:P9:2 | Maximum RX packet length (MAX_RX_LENGTH) | | 37 to 255 | Bytes | | RF-PHY:P9:3 | Maximum TX packet length (MAX_TX_LENGTH) 2M | | 37 to 255 | Bytes | | RF-PHY:P9:4 | Maximum TX packet length (MAX_TX_LENGTH) S=2 | | 37 to 255 | Bytes | | RF-PHY:P9:5 | Maximum TX packet length (MAX_TX_LENGTH) S=8 | | 37 to 255 | Bytes | | RF-PHY:P9:6 | Maximum RX packet length (MAX_RX_LENGTH) 2M | | 37 to 255 | Bytes | | RF-PHY:P9:7 | Maximum RX packet length (MAX_RX_LENGTH) S=2 | | 37 to 255 | Bytes | | RF-PHY:P9:8 | Maximum RX packet length (MAX_RX_LENGTH) S=8 | | 37 to 255 | Bytes | | RF-PHY:P10:1 | Maximum TX mode output power | | -20 to 10 (CSA5 unsupported) -20 to 20 (CSA5 supported) | dBm | | RF-PHY:P11:1 | Inband Image Frequency (2Ms/s) | Low frequency | 3 | MHz | | RF-PHY:P11:2 | | Middle frequency | 3 | MHz | | RF-PHY:P11:3 | | High frequency | 3 | MHz | | RF-PHY:P12:1 | Value n for Intermodulation test (2Ms/s) | Low frequency | 4 | Integer | | RF-PHY:P12:2 | | Middle frequency | 4 | Integer | | RF-PHY:P12:3 | | High frequency | 4 | Integer | | RF-PHY:P13:1 | Inband Image Frequency (Stable Modulation Receiver) | Low frequency | 3 | MHz | | RF-PHY:P13:2 | | Middle frequency | 3 | MHz | | RF-PHY:P13:3 | | High frequency | 3 | MHz | | RF-PHY:P14:1 | Value n for Intermodulation test (Stable Modulation Receiver) | Low frequency | 4 | Integer | | RF-PHY:P14:2 | | Middle frequency | 4 | Integer | | RF-PHY:P14:3 | | High frequency | 4 | Integer | | RF-PHY:P15:1 | Inband Image Frequency (Stable Modulation Receiver, 2Ms/s) | Low frequency | 3 | MHz | | RF-PHY:P15:2 | | Middle frequency | 3 | MHz | | RF-PHY:P15:3 | | High frequency | 3 | MHz | | RF-PHY:P16:1 | Value n for Intermodulation test (Stable Modulation Receiver, 2Ms/s) | Low frequency | 4 | Integer | | RF-PHY:P16:2 | | Middle frequency | 4 | Integer | | RF-PHY:P16:3 | | High frequency | 4 | Integer | | LE支持最大数据包长 | 255 | | | | | 蓝牙跳频使用 | 蓝牙跳频用的是FHSS | | | | | Dwell time | 最小625us(跟数据包有关系) | | | | | Bluetooth Security Mode :描述安全级别和模式 | mode3 | | | | | Bluetooth Secure Connection :是否支持安全连接 | 支持 | | | | | Bluetooth Service Level︰描述到/来自音频源/接收器的通信渠道使用的接口，协议，端口;source;destination (如A2DP | a2dp sink | | | | | AHF（自适应跳频） | 支持 | | | | | LE 跳频 | 最大40；最小：0 | | | | | BR/EDR 跳频 | 最大79；最小：0 | | | | | Stable Modulation/TX/RX | 支持 | | | | |     如果是LE的話請問最大可發射的數據包是多少？ 最大可接收的數據又是多少？ | | | | | |     发射80KB/S,接收80KB/S（此速度是和我们自己的BLE设备连，手机话，手机自己有限制速度，没这么快，一般5KB/S） | | | | | | 蓝牙标准 | IEEE802.15.1 | | | |